Snow Remover Power Unit

General Description

This power unit is specially designed for all kinds of trucks to add different types of skis,providing skis with lifting and left-right swing functions.Different loops and different valves are optional.

Outline Dimension

Hydraulic circuit optional 060

Model Specifications

Special Notes

1. For different fiow rate pump. pressure and motor power. please check the ordering guidanoe.

2. This motor is based on gap working system S2=2 - 4min(continuous working time), so it cannot run continuously.

3. Before installation, the cylinder, oil pipe, joint and other hydraulic components must be cleaned and free from any impurities.

4. The viscosity of hydraulic oil should be 15-68cst and should be clean and free of impurities.HM46 hydraufic oil is recommended.

5. Check that whether there is enough oil in the oil tank immediately after the first operating of the system.

6. The hydraulic oil should be replaced after the first 100 hours' use of the system, and change the oil every 3,000 hours after that.