Power Units For Wing Van

General Description

This hydraulic power unit is usod for the wingspan van control system, which has two kinds: single wing plate opening and double wing plate opening.It adopts the electromagnetic directional valve to realize the opening and closing of the wing plate.The cloning speed of the wing plate is adjusted by the throttle valve,with reliable pertormance and stabie qualty.

Outline Dimension

Hydraulic circuit optional 046

Model Specifications

Special Notes

1. For different fiow rate pump,pressure and motor power,please check the ordering guidance.

2. This motor is based on gap working system S2=2 - 4min(continuous working time),so it cannot run continuously.

3. Before installation,the cylinder,oil pipe,joint and other hydraulic components must be cleaned and free from any impurities.

4. The viscosity of hydraulic oil should be 15-68cst and should be clean and free of impurities.HM46 hydraulic ol is recommended.

5. If you need manual oil discharge device for emergency,please specify when ordering.

6. Check that whether there is enough oil in the oil tank immediately after the first operating of the system.

7. The hydraulic oil should be replaced after the first 100 hours'use of the system, and change the oil every 3,000 hours after that.