Dc Motor Pump Group

General Description

Consisting of a heavy duty DC motor and the CBK gear pump,this pump–motor group is typically used as a power station of a complex hydraulic system.

Outline Dimension

Hydraulic circuit optional 095

Model Specifications

Special Notes

1.For different fiow rate pump.pressure and motor power,please check the ordering guidance.

2.This motor is based on gap working system S2=2 - 4min(continuous working time). so it cannot run continuously.

3.Before installation,the cylinder.oil pipe,joint and other hydraulic components must be cleaned and free from any impurities.

4.The viscosity of hydraulic oil should be 15-68cst and should be clean and free of impurities HM46 hydraulic oil is recommended.

5.The hydraulic oil should be replaced after the first 100 hours'use of the system, and change the oi every 3,000 hours after that.