Basketball Rack Hydraulic Power Unit

General Description

The hydraulic power unit is designed for electric basketball rack,it is made up of high-pressure pump,motor,manifold block,plate valve,cartridge valve, tank and so on.There are two independent circuits for power up and gravity down for the lifting movements of rebounds and backboard , pressure compensation valve makes it descent very smoothly.

Outline Dimension

Hydraulic circuit optional 027

Model Specifications

Special Notes

1. For different flow rate pump.pressure and motor power, please check the ordering guidance.

2. If you need manual oil discharge device for emergency, please specify when ordering.

3. This power unit can not run continuously (1 min ON,9 min OFF),it can work repeatedly.

4. Before installation, ensure that the hydraulic components such as the oil cylinder,oil pipe and joints are clean and free from any impurities.

5. The viscosity of hydraulic oil should be 15-68cst and should be clean and free of impurities. HiM46 hydraulic oil is recommended.

6. This hydraulic power unit is suitable for horizontal installation.

7. Check that whether there is enough oil in the oil tank immediately after the first operating of the system.

8. The hydraulic oil should be replaced after the first 100 hours'use of the system, and change the oil every 3,000 hours after that.