Pallet Truck Power Unit

General Description

This mini hydraulic power unit is made up of DC motor , high pressure gear pump, hydraulic valve, tank and other components. It is usually used for the small stackers and pallet trucks.Oil returns to the tank when electromagnetic unloading valve unloads,and the down speed is controlled by pressure compensating flow control valve.

Outline Dimension

Hydraulic circuit optional 010

Model Specifications

Special Notes

1. For different flow rate pump,pressure and motor power,please check the ordering guidance.

2. This motor is based on gap working system S2-2 - 4min(continuous working time),so it cannot run continuously.

3. Before installation,the cylinder,oil pipe,joint and other hydraulic components must be cleaned and free from any impurities.

4. The viscosity of hydraulic oil should be 15-68cst and should be clean and free of impurities.HM46 hydraulic oil is recommended.

5. If you need manual oil discharge device for emergency , please specify when ordering.

6. Check that whether there is enough oil in the oil tank immediately after the first operating of the system.

7. The hydraulic oil should be replaced after the first 100 hours'use of the system, and change the oi every 3,000 hours after that.