Wheelchair Lift Power Unit

General Description

This power unit is specially designed for wheelchair lifter for disabled vehicles, which can be electrically controlled to rise or manually controlled to rise,the descending is controlled by the uploading solenoid valve. The quantitative pressure compensating throttle valve makes the descending steady.

Outline Dimension

Hydraulic circuit optional 099

Model Specifications

Special Notes

1. For different flow rate pump,pressure and motor power,please check the ordering guidance.

2. This motor is based on gap working system S2-2 ~ 4min(continuous working time),so it cannot run continuously.

3. Before installation,the cylinder,oil pipe,joint and other hydraulic components must be cleaned and free from any impurities.

4. The viscosity of hydraulic oil should be 15-68cst and should be clean and tree of impurities.HiM46 hydraulic oil is recommended.

5. If you need manual oil discharge device for emergency,please specify when ordering.

6. Check that whether there is enough oil in the oil tank immediately after the first operating of the system.

7. The hydraulic oil should be replaced after the first 100 hours'use of the system, and change the oil every 3,000 hours after that.